Axis
  Sitemap |
 
Roof windows
Blinds
INSTALLATION SEQUENCES JUST FOLLOW THESE STEPS print page

.Roof windows
Making the Opening

Making the opening part

Marking out

Mark out the opening on the underside of the roof membrane. Do not remove more than necessary - you can always cut it back later.

top

Removing the membrane

Cut out and remove the membrane, exposing the battens and the roof covering.

top

Tiled roof

If you have a tiled roof, carefully begin to remove the tiles from inside. Make sure the area below this roof area is clear to avoid injury or damage if an accident occurs.

top

Composite thin tile covering

If you have composite thin tile covering, you may need to drill and cut through to make the initial opening.

top

Removing nails

If you have a slate covering it may be necessary to use a slate ripper to remove the nails.

top

Removing tiles/slates

Remove sufficient tiles/slates to allow a good working area. Don't be tempted to remove too many though - you'll have to put them back later!

top

top

Removing battens

Remove battens to the extent of the framed area.

top

 
 
PRODUCTS | PRACTICAL ADVICE | INSTALLATION | SECURE AREA | SUPPORT | DOWNLOADS
TECHNICAL SPECIFICATION | MAINTENANCE | SITEMAP
  © 2018 AXIS90. All rights reserved / Terms & conditions / Privacy policy / General Terms of Sale and Delivery W3C